Bargeloob's ST-1M

[wokkaboy]

hopefully the posty arrives today Barge ! Nice advice using a beer can or flat plastic to spread the glue, might try that next time.
That flame maple deal is cheap if it does 2 axes. Bit worried about 2 x 6" wide pieces is only just over 300mm wide, from memory a ST is more like 330mm at it widest point, although you will be chopping off a bit of width.
I'll wait till your flame maple veneer arrives next week Barge if you can please measure the total width, if its about 330mm I'll be ordering some for sure

[bargeloobs]

hopefully the posty arrives today Barge ! Nice advice using a beer can or flat plastic to spread the glue, might try that next time.
That flame maple deal is cheap if it does 2 axes. Bit worried about 2 x 6" wide pieces is only just over 300mm wide, from memory a ST is more like 330mm at it widest point, although you will be chopping off a bit of width.
I'll wait till your flame maple veneer arrives next week Barge if you can please measure the total width, if its about 330mm I'll be ordering some for sure

Yeah I worked it out to be slightly less than 330 but either way (like you mentioned) as I'm going for a custom shape I can cut it down to fit. The veneers might prove to be a bit of a problem on a regular Strat shape I would imagine.