Quote Originally Posted by fender3x View Post
I agree that the center blocks are too narrow. I have made that observation/complaint elsewhere. However, the hole on the south side of the stop-tailpiece looks a bit more normal. There is normally a small, round hole in that position to run a ground wire, and that's what it looks to me like you have. The top looks like the kind of break-through that you get when the hole is not entirely in the center block, but the bottom may be OK. If it were me I would still reinforce it with a small piece of wood.

The south side of the south hole could be too close to the edge of the center block, but just the fact that there is a hole does not mean it's fatally flawed. With both my bodies it was the south hole that was off the block. If you do glue a piece to the side there is an additional consideration. You need to be careful that the block you glue into place does not interfere with the hole for the jack which is also quite close to the center block.

Here's a dumb question... Have you PM'd Adam? That has been the way I have gotten the quickest response from him in the past. He just posted a couple of days ago so he should be around... Keeping fingers crossed that he gets in touch. Seems quite out of character.
PMed Adam?. No. I had PMed pitbull guitars in insta and in Facebook. I don't have his number to send a personal message. It's not listed anywhere.

He had replied to me on Facebook messenger through pitbull guitar handle on Saturday that he will get back to me yesterday since it was easter holidays. But he has not done that yesterday. It's past noon today in Australia now and I haven't got any reply from him yet.

Do u know any Other way to communicate with him or with anyone in pitbull guitars? Even their phone goes to voice mail.

Sent from my NE2211 using Tapatalk