Quote Originally Posted by thiscocktail View Post
Good day everyone. Little update. I shaped a thiny piece of wood to fill the gap into the neck socket. Have to refinish it but I have to check first, two three times, the bridge position,at first sight something is wrong with position and predrills but one thing at time.
And I start to work on headstock...first time shaping wood
Shaping https://imgur.com/a/pG4l59R
Yes, although a different TL kit to yours my bridge was out and needed moving 3mm towards where the control plate goes. The original holes were covered by the bridge. I glued tooth picks in the old holes. Once you fit the neck, fit the bridge and put the 2 E strings on and check the alignment of the neck to see where the strings sit.