PSH-1 Build

[vivek_rc]

Might go the route of the shim, I actually have some maple veneer pieces I bought from Amazon to test the stains, they are 2 mm thick. Have been reading Simons instructions on your post on how Tom make the shim, very detailed, and will have a go at it and see if I can get this to work. I’m wondering if this is a construction problem from the factory? I would think it they use CNC machines the should get the required pocket angle pretty accurate out the door?

[mrpearson]

Might go the route of the shim, I actually have some maple veneer pieces I bought from Amazon to test the stains, they are 2 mm thick. Have been reading Simons instructions on your post on how Tom make the shim, very detailed, and will have a go at it and see if I can get this to work. I’m wondering if this is a construction problem from the factory? I would think it they use CNC machines the should get the required pocket angle pretty accurate out the door?

I would try a 2mm shim first. 1.5mm is just shy of where I would like it to be. Tip - When I made mine I had 3mm piece of aluminium straight edge from Bunnings that I positioned 2x the length of the shim to get the height right. Pretty cheap and precise thickness. You will also need a roll of strong double sided tape to hid the shim in place and to tape the sand paper to something flat. I went though half a roll making my shim.

I have just set my neck tonight so hopefully I can get a decent action.


Sent from my iPhone using Tapatalk