Can't get to my timber 'cause it's at the Men's Shed, which is closed due to Covid. Hardware is slowly trickling in. Fret wire came in yesterday. Here's what I have so far:
All that's left is for me to order some pick guard material, three 500k pots, a 500k push/pull pot, three caps (older Rics had 3 not 2 apparently), and a 3 way switch. Not sure if I should use log taper for all 4 pots or if I should use linear for the tone pots.. the Ric scematic doen''t specify.
Next week I'll attempt to make the bezel for what would normally be the bridge pickup out of 0.9mm stainless. Buying a bezel is way too expensive.