Results 1 to 10 of 27

Thread: JZ-6 Build No 7

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    GAStronomist Simon Barden's Avatar
    Join Date
    Oct 2016
    Location
    Reading, UK
    Posts
    10,547
    You were doing so well until you got to 'sea foam green'.

    Just a bit concerned that 4 pickups might provide a lot of magnetic pull on the stings and cut down on sustain. It may also increase the tendency to get wolf notes unless the pickups are dropped down quite low (which will then give thinner and quieter sounds). All big 'mays' and you'll probably be fine. But if it does happen, and the singles are stock kit ones, then there's always the option of having one as a dummy pickup, not wiring it in and removing the magnet that's stuck on to the back of it, so it still looks the same. Or if its a RWRP pickup, leave it so that it's connected up when either of the other single coils (only) are selected, so you get a degree of hum cancelling. Even if it's not RWRP, as you've removed the magnet, you could just swap the coils output wire connections over.

  2. #2
    Member stansby40's Avatar
    Join Date
    Mar 2019
    Location
    Tasmania
    Posts
    93
    Quote Originally Posted by Simon Barden View Post
    You were doing so well until you got to 'sea foam green'.

    Just a bit concerned that 4 pickups might provide a lot of magnetic pull on the stings and cut down on sustain. It may also increase the tendency to get wolf notes unless the pickups are dropped down quite low (which will then give thinner and quieter sounds). All big 'mays' and you'll probably be fine. But if it does happen, and the singles are stock kit ones, then there's always the option of having one as a dummy pickup, not wiring it in and removing the magnet that's stuck on to the back of it, so it still looks the same. Or if its a RWRP pickup, leave it so that it's connected up when either of the other single coils (only) are selected, so you get a degree of hum cancelling. Even if it's not RWRP, as you've removed the magnet, you could just swap the coils output wire connections over.
    Thanks Simon all good points. I had originally thought to keep one of the pickups as a dummy one. How did they get the position of the pickups so wrong? Even if I keep one as a dummy which one, the one nearest the bridge or the middle of the three?
    Build 1 AGM-1
    Build 2 TLA-1
    Build 3 ES-3
    Build 4 TL-12F
    Build 5 ST-1

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •