All tested and boxed up.

Had one issue with no sound when testing the circuit and it came down to one link I hadn't tested for continuity. Reflowed some solder in and boom away she went.

I see how sensitive getting that sweet spot to bias will be, but going to go there with a fresh and rested mind. Just happy that it all works.

The decal plan was a COMPLETE fail. 3 goes , mucked them all up. Got them to a good point and then one last little move or manuover ripped something off. Wasn't happy with getting it as smooth as I wanted so I was probably working the decals for too long. Dang oh well. I have a new plan now, but that will take some time to arrive. So i will reveal the concept when that comes to fruition.

I have been enjoying minimising the earth points by using a ring terminal on this and the last build. Looks neater too. Same principal as solder lug terminals, but free cause I already have them and a set of crimps. This build it went under the pot and last build went onto one of the jacks earthing out with the enclosure.