Dual Build: GSJ-1 and GSM-1

[Simon Barden]

From an earlier post in this thread:

One thing I did notice on both kits is that the supplied truss-rod covers are 2-screw standard Gibson types, whilst the kit needs the 3-screw type. Luckily I have a stock of G-style 3-hole truss rod covers!

So already spotted, but thanks.

I've mentioned the truss rod cover, the badly placed fretboard locating pins and the lack of pre-drilled bridge ground wire holes to Adam on these G-series kits, and he'll have a word with the factory as he says they are very responsive. So hopefully the next batch from them will have these small issues sorted.

[Rodc]

From an earlier post in this thread:


So already spotted, but thanks.

I've mentioned the truss rod cover, the badly placed fretboard locating pins and the lack of pre-drilled bridge ground wire holes to Adam on these G-series kits, and he'll have a word with the factory as he says they are very responsive. So hopefully the next batch from them will have these small issues sorted.

Sorry, missed that. I might have to make one

[J.R.303]

From an earlier post in this thread:


So already spotted, but thanks.

I've mentioned the truss rod cover, the badly placed fretboard locating pins and the lack of pre-drilled bridge ground wire holes to Adam on these G-series kits, and he'll have a word with the factory as he says they are very responsive. So hopefully the next batch from them will have these small issues sorted.

Ah, just seen this.
How do I ground to the bridge post then as it looks a difficult one to drill?