A bit of pedal p*rn for you DIY'ers

[McCreed]

I can never post the interior of one of my pedal builds again

That's how I feel when I see some of the guitar builds that come out of this place!

I have found layouts for both, but I really don't need more overdrives just now.

Well, OK, maybe just one more ...

I went through a dual overdrive pedal phase a few years ago. I had a heap, but this is the only one I've kept.
Not only because it sounds good, but it's just so unique.

The builder did a variation on the switching via a 2-way clipping switch and a 3-way Fat switch to the Boiling Point circuit, and toggle on the Bluesbreaker side switches between clean boost and overdrive.

I still have a thing for OD's but I've mostly curbed my apatite for them and way less obsessive about them.

[jugglindan]

I went through a dual overdrive pedal phase a few years ago. I had a heap, but this is the only one I've kept. Not only because it sounds good, but it's just so unique.

Agreed. I would never sell that pedal. It's a work of art. If you don't want to use it anymore you could take the lid off and hang it on the wall!

The builder did a variation on the switching via a 2-way clipping switch and a 3-way Fat switch to the Boiling Point circuit, and toggle on the Bluesbreaker side switches between clean boost and overdrive.

My OD-2 has both of those mods. The 3-way EQ: flat, mid-hump, fat (boosts low end), and switchable clipping between silicon diodes, no clipping and my now socketed LEDs.