I have strung it up with the strings supplied (minor gripe - the kits are advertised as being supplied with Ernie Balls but none of mine have been). These are lighter gauge than I normally use so set up will need some tweaking when I change them but is playing quite nicely straight away.
Of the three PB kits and one other that I've built so far, this feels the most 'factory' from the word go so I moust be learning something as I go along
I thought it would be a good idea to leave the wires a bit over long to make installation easier which was probably true but means they keep trying to make an appearance in the F hole. On the to do list to shorten them at some point.
Incidentally, as recommended on here I bought some flexible tube to fit over the stems on the pots to pull them into position but the stuff I got had quite a thick wall which bulged out when fitted to the pot and was slightly too big to fit through the holes in the body.
I ended up using some heat shrink tube which I only had in short length so taped that to a cable tie and that worked nicely.
So another enjoyable build and I'm really happy with the end result.
Will just enjoy playing and let it settle in for a while before I restring and fine tune the set up.