Precision Bass wiring

[Simon Barden]

Make a fair length of bare wire and just sit the bridge on it. If you use a fairly thin bit of wire for the ground wire here, you can probably knot it first, so that the knot sits in the vertical hole you drilled first, which then stops the wire from being pulled too far into the cavity. Just have the exposed wire sitting on the body and you can spread the strands out so that it doesn't add any real thickness.

[fender3x]

"you can probably knot it first, so that the knot sits in the vertical hole you drilled first, which then stops the wire from being pulled too far into the cavity."

That is such a good idea, and yet I have never heard it suggested before, and I certainly never thought of it...



Sent from my ONEPLUS A3000 using Tapatalk