Gosh I really am awful at getting builds done in timely fashions. Small update, pics soon.

Cleaned up the binding, edges and most of the stain runs. Still a couple of little bits visible but I'm ok with them. Little accidents and flaws are what makes something your own.

Went over the back of the neck with Purple, the Pink just didn't come through super well on the non-figured Maple.

Snagged some PRS SE pickups for cheap to pop in there. Heard good things from the videos I've seen with them and always prefer the extra options of 4-wire pickups. Will be hooking them up with Series/Parallel switching (hopefully just a single Master Toggle for it).

Gonna start oiling it tomorrow, expecting good things as my test pieces with the oil didn't tint the pink drastically.

And just need to pick up some screws to lock the bridge down. Even though I did a try fit when I got it, I didn't investigate thoroughly enough to check the smaller things like screws. I think it was also missing a Trem arm, but I've heard bad things about these Trems, so I'll be locking it off since there is a bit in the back of it to do so.

I think that's pretty much all. Was good to finally get back in to it, even if it's a small step overall. Have a good day, everyone!