Upgrading TL-1 with a 4 way lever switch?

[Bakersdozen]

Hi folks,

Would you know based on experience whether the routed cavity on the TL-1 is deep enough should one consider to fit in a 4-way lever switch?

Cheers.

Can't comment on the TL-1, but it did fit in my JTL-1. What you have to watch for if it does fit or you edit the route to accept it is...

The slot on the control plate for the switch may not have enough travel for the extended throw of the 4way switch. I was scratching my head for ages trying to figure out why the end 2 positions were not engaging properly. I had to file out to extend the slot at both ends until the switch was able to reach its full throw. Not much only a few mm each side by memory.