Woltz's semi-scratch strat build

[Sonic Mountain]

MDF templates routed off the master acrylic ones, unfortunately the router bit became friends with the acrylic in a couple spots but the divets are only very small and on the inside of the cavities near the centre of the body. Just need to do the f holes and mark the string through holes to drill the mdf template.

Ooh lucky. I had the same issue with my V templates in MDF, doesn't take much for the bit to grab it if you aren't being super careful. That was the main reason I went for mild steel with the new ones... probably be up for new router bits before I wreck them

[Woltz]

Ooh lucky. I had the same issue with my V templates in MDF, doesn't take much for the bit to grab it if you aren't being super careful. That was the main reason I went for mild steel with the new ones... probably be up for new router bits before I wreck them

Yeh that's a good idea. Assuming the templates are more expensive than the router bits haha.

The more I get into this build, the more I get tempted to do the neck from scratch as well.