1) This is where I'm at after bit more fluffing around. Not confident with the pick guard. Can it be reshaped? what Tools?
I think if i can shave a bit of at the the neck & where it meets the control plate I may use it (I still like what cork sniffer has done)
2) the stings look ok down the neck I'm leaning towards moving the bridge 2mm towards the low E string??
3) If i do move it a few mm will it impact on the stringing up via the through holes on the body?? its only 2mm?? is it even worth doing it for that amount?
4) And then there is these holes that I didn't put there? I noticed these as i was lining up the bridge which seems ok? the PU is up against the cavity wall. One of the reasons I'm leaning towards moving the bridge 2mm??
don't know?? still not feeling confident.
Reply With Quote
