Phroz STA-1M, ST-M, TL-1

[Bakersdozen]

How long between each coat of clear and did you block back at all?

Looking great!

Edit: all good just read your guide above. Cheers!

Sent from my Pixel 2 using Tapatalk

[phrozin]

How long between each coat of clear and did you block back at all?

Looking great!

Edit: all good just read your guide above. Cheers!

Sent from my Pixel 2 using Tapatalk

i do 1 vertical coat then 1 horizontal coat and 1 vertical coat all together then pending on the weather 10 to 20mins between every 3 header coats i lay 6 coats then dry over night then 800 w&d then the same again dry over night w&d 1200 then again i flow coat them when on the gun i use a 2to1 mix if using rattle i flow coat but only 2 coats if you have done it right you should have a very flat and shinny body off the gun then leave rattle can 1 full week and gun 3 to 4 days before polishing usually only need a light sand with 2000 then buff with sponge pads everyone can do it i have put a few posts how to get a glass finish on it, not really hard the real hard part is the dye or stain i like a good streak free and good penetration before i go anywhere near the clear thats were its at the prep you do determines the finish you'll get any spray painter will tell you the same pep is where its at not the clear stage :-)