Ideally you want something like a 3/4 inch following bit with a 5/8” OD x 1/4” ID bearing on the end, that should give you the 1/16” or 1.6(ish)mm rebate you want. You might be able to go smaller than that if you can find the right bearings.
Ideally you want something like a 3/4 inch following bit with a 5/8” OD x 1/4” ID bearing on the end, that should give you the 1/16” or 1.6(ish)mm rebate you want. You might be able to go smaller than that if you can find the right bearings.
FrankenLab:
Turning tone wood into expensive sawdust since 2016!
Posting Permissions
Reply With Quote