Are you testing it still wired to the push/pull? If possible, test the switching on the spare pole of the push/pull to see if it has maybe failed locked in the 'up' position.
Are you testing it still wired to the push/pull? If possible, test the switching on the spare pole of the push/pull to see if it has maybe failed locked in the 'up' position.
Scott.
Hi Scott, i have removed all wires from the switch and tested across them in isolation. That way thought i could narrow down where the problem might be?Originally Posted by WeirdBits
Got a spare new switch and can run some tests on it and compare to existing one. Just in the middle of another soldering job and should be done in about 10 mins.
Sent from my SM-A520F using Tapatalk
# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
Other than ohm differences spare new push/pull pot reads the same across all lugs when compared to one installed in guitar, and that is when switch raised and lowered.
Sent from my SM-A520F using Tapatalk
# 1 - EX-5 https://goo.gl/fQJMqh
# 2 - EX-1 https://goo.gl/KSY9W9
# 3 - Non PBG Tele https://goo.gl/W14G5g
# 4 - Non PBG J Bass https://goo.gl/FbBaFy
# 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
# 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
# 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8
Posting Permissions
Reply With Quote