Hey all

This is overdue because I got my kit and started my build around the beginning of Feb.

The catalyst for this has been that I had a Tele for a fair few years that was a Partscaster, entirely put together out of parts but it was a magic guitar, the go-to guitar when all else failed, and I used it on countless gigs, EP and album recordings and loved it.

Sadly it went a little while ago due to financial pressures.

I've covered off early parts of this build in my welcome thread:

http://www.buildyourownguitar.com.au...ead.php?t=7126

Bunch of Instagram links there that may not work, as I've just made my profile/account private. I've had to do this due to some VRO related nastiness going on in the last few weeks.

I have tried to upload photos here in the past but haven't figured out how to make them smaller size/data yet.

Here's basically how my build has gone in a few points:

1) Get kit. It's like Christmas day.

2) Spend three or four days sanding. Now I don't order the sanding paper from the website, I use stuff I get from Bunnings, but pretty much the same sizes/gradients/whatever it's called.

3) Pretty happy with the sanding, it's really brought out the grain. Apply first coat of Stain. Haven't done this before, go really gung-ho with the front/top of the guitar, barely leave anything for the back. Dingotone "Coolangatta Gold" selected for the body.

4) Sand the neck, then use Accacia to stain neck. Now I don't really read/follow instructions and I use the stain on the whole neck, even the fretboard which I'm later told most people tape up and don't stain/touch. Looks good anyway, has that vintage yellow look.

5) Do another Stain coat on body, happy with colour/look

6) Apply intensifying coat. After this has cured, I add another intensifying coat, possibly a bit drunk, apply too much and really cake it on.

7) Get bored, put guitar together as a whole. Good exercise because I can see what it will look like and it looks great.

8) disassemble guitar, sand back really thick intensifying coat.

9) Patch up Stain coat - stain bits that are looking pale/colourless as a result of the sanding.

10) Apply intensifying coat again