Ive went over a few things you both mentioned. thanks for the advice.
I found some of the routing was preventing the neck from seating properly, so I cleaned this up with a chisel.
I tried putting a straight edge on the neck to check fret height and nothing jumped out as being too high but when I used a short razor blade that would only go over 3 or 4 frets it high lighted that frets 12,14, 19 are high as the blade would rock on the high frets. ill level these with the other frets and see how it goes.
I included a photo of the nut height let me know what you think if I need to lower it or not ?
Reply With Quote
