cool fret slot jig Frankie, so it clamps the fingerboard down and you use the square edge to rest the saw against ?
cool fret slot jig Frankie, so it clamps the fingerboard down and you use the square edge to rest the saw against ?
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Not yetOriginally Posted by wokkaboy
the brown bar is a square rest for the saw and the long bars either side are squared to that to assist with marking up the fret board.
I've got a couple of small toggle clamps that will go either side of the saw rest to actually clamp the board and sliding bed down but I have yet to fit them. That test was done holding the board in place by hand. It actually worked pretty well but your hand is going to start aching if you've got a whole board to slot.
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
Reply With Quote
