Community Kit Build Number 4

[Dedman]

yup very thin border to hide some glue I couldn't shift. Red is already done

[wokkaboy]

ok look forward to pics after the burst is done Dedman !

[Dedman]

first clear coats are on

[wokkaboy]

looks great Dedman, is that black strip around the centre to cover more glue ?

[Dedman]

yea, it was pretty thick, by the time I'd dug it out I had to fill it with timbermate

[wokkaboy]

fair enough Dedman, looks cool anyway. How did you clean the binding did you mask it or clean/scrape it after the burst ?

glad you cover your motorbikes, would hate any overspray to land on them !

[Dedman]

I masked it then had to scrape it anyway there is always some that gets under. I just use a bit of 800 grit paper folded down to about a centimetre square and us my thumb as a guide on the edge.

[FrankenWashie]

first clear coats are on

me likey!!

[Dedman]

stunning day here today, I sanded and put 2 more coats on, so that's it, just final sand and polish to go on the body. Bad news is my 1k push pull pot arrived...but it's not a push pull, the idiots sent a normal one.

[wokkaboy]

which supplier sent the wrong pot Dedman ? they should replace it at their cost but will delay the wiring stage