DIY Custom FX Pedal Board

[wokkaboy]

good job Doc, so the pedals just sit on the carpet or do you velcroe them on ?

[DrNomis_44]

good job Doc, so the pedals just sit on the carpet or do you velcroe them on ?

Cheers, and yep, the pedals are Velcroed-on, or will be, the beauty of that is you can easily remove the pedals and place them elsewhere on the board, some people like to use Zip-ties to keep them in place.

The Velcro will stick to the carpet tiles.

I bought some Velcro tape from my local Officeworks shop, but it was a bit expensive at about Au$17.00 each for a 25mm by 1M roll, I'm sure there are other places where I could buy it at a cheaper price though.


Here's another pic of the Pedalboard, but this time with some pedals on it, they're not held in place by Velcro, yet though:





I was able to fit sixteen of my pedals plus the power supply on the Custom Pedalboard I made.

[FrankenWashie]

I bought some Velcro tape from my local Officeworks shop, but it was a bit expensive at about Au$17.00 each for a 25mm by 1M roll, I'm sure there are other places where I could buy it at a cheaper price though.

You might try Spotlight if there is one near you, either that or another specialist sewing store, they usually do that sort of thing at a reasonable cost/m.

[DrNomis_44]

You might try Spotlight if there is one near you, either that or another specialist sewing store, they usually do that sort of thing at a reasonable cost/m.

Cheers, I'll see if there is a Spotlight Store in Darwin later on tonight.