no worries Ultpanzi. Some nuts have a flat and some a curved bottom. Probably easier to get a flat bottom nut. Might pay to get a 3mm wide router bit for the channelling but if you have a small chisel and do a practice run you should be ok
no worries Ultpanzi. Some nuts have a flat and some a curved bottom. Probably easier to get a flat bottom nut. Might pay to get a 3mm wide router bit for the channelling but if you have a small chisel and do a practice run you should be ok
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in