Quote Originally Posted by patrickparks1 View Post
I'm pretty sure if I have to replace the nut, this is the one that I need. I believe the original nut from the exa7 kit is a 48mm x 6mm.
https://graphtech.com/products/black...str-nut-48-x-6
The one in the link should be fine. Usually a replacement nut would be slightly oversized so that you can sand it to be flush on the sides. Probably best to wait to finish the neck until you get the nut so that you can make everything flush before applying finish.

Sent from my LE2125 using Tapatalk