Adam is the owner of Pitbull and this site. He is very helpful and reasonable. You would have got an automatic email from his address when you ordered the kit. Just reply and let him know whats going on and I'm sure you will be able to work something out. It's the nature of these kits that there are some manufacturing errors. 9 times out of ten it can be fixed or mitigated, but sometimes its a fault that can't be rectified. It is a bit of a shame you didn't notice this until you were so far into the build but I don't think that will be a problem.
EDIT: Just saw its a set neck. That makes changing it tricky, but not unachievable. Did you use titebond? You may have to carefully score through your shielding then steam it off. I have seen it done a couple of times on here without any major dramas.
Reply With Quote