Just joined the forum and about to start my second Pitbull, just wanted to try and clear up some questions.
The kit is a GR-1SF.
The supplied electrics included 2x A500K pots and 2x B500K pots.
This model has 2x pickup volumes and a master volume and 1x master tone.
However, the general instructions for builds on the website state A500K for tone and B500K for volume.
Question, will I have problems if I use an A or a B for tone or volume?
Secondly, there were 2x green capacitors supplied with the kit but the wiring diagram only shows 1x capacitor soldered to the master tone pot. Should there be 2x shown and where would the other be attached? Master volume perhaps?
These questions maybe more for Pitbull themselves but would like to clear them up before I start anything.
Looking forward to any interaction and advice.
Regards
JohnL