Originally Posted by
Mark B-C
Hi Stan, All handwork,Only use Dremel for small inlays (Neck heel,Truss cover & engraving) I sand infill materials a little thicker than the cut-out area, and then sand down flush when glue set, I fine shape after cutting-out with sandpaper If there are any small gaps I fill with woodfiller/nitro-cellulose/super glue - depends on size of gap. After initial sanding, coat with n-c and sanding sealer, and then rub-down ready for finishing. I have found it necessary to make my own very small tools. Easier to inlay on laminated wood, because you can cut the outline and then just remove the top veneer of the laminate. Solid/carved tops much more difficult & don't recommend inlays on bottom bouts as can dampen vibration. Sent some photos via Adam & asked him to send to you. Cheers Mark B-C