PRS - 1TS - First Build

Quote:

---

Originally Posted by daviduzzo29

Ma poi la finisci con smalto alla Nitro? che sembra sia quella che dona più bello effetto finale!

---

I like nitro finishes, I think they age well. and they are easy to repair if they get damaged. But there are lost of other options out there and nitro has a lot of toxic solvents so you need to take care when and where you spray - and you must use a face mask that's suitable for solvent spraying.

Quote:

---

Originally Posted by Zandit75

NO doubt you've already seen plenty of comments about the LP-1S, but just remember, the veneer is stupidly thin, so take it very careful when it comes to sanding it.

---

Thanks Zandit, yes I noticed this... my kit arrived yesterday. Super thin! What did you do in terms of sanding the top?

Hey Slayer, so this is the LP-1S kit I presume. For a spalted veneer I just give it a light sand with 320 grit paper. The pores/pits and small crevices will be filled with clear coat so don't worry when it doesn't feel flat when you run your fingers over. Remember wear the dusk mask and have a fan blowing the dust away and do it outdoors !

Quote:

---

Originally Posted by wokkaboy

Hey Slayer, so this is the LP-1S kit I presume. For a spalted veneer I just give it a light sand with 320 grit paper. The pores/pits and small crevices will be filled with clear coat so don't worry when it doesn't feel flat when you run your fingers over. Remember wear the dusk mask and have a fan blowing the dust away and do it outdoors !

---

Hey Wokka, yep the LP-1S. Thanks for that... whilst my veneer isn't as nice as Zandit's it will still look good!

Good stuff Slayer, look forward to pics of the kit you scored in a new build diary. Think Zandit won the lucky dip contest with his veneer. I haven't seen a bad spalted veneer yet, they are all so different. As long as you have some nice contrast in the grain and some nice dark spalt lines. Sometimes you can even see some flaming

Quote:

---

Originally Posted by wokkaboy

Good stuff Slayer, look forward to pics of the kit you scored in a new build diary. Think Zandit won the lucky dip contest with his veneer. I haven't seen a bad spalted veneer yet, they are all so different. As long as you have some nice contrast in the grain and some nice dark spalt lines. Sometimes you can even see some flaming

---

Yep, once I finish this build I will be onto it!

Yep, pretty much as Wokka described. I still have some ridges in my finish, but then I probably only did about 7-8 final coats of DT that were very thin.
Don't go comparing mine to yours!! Depending on how you execute your design plan, it could easily end up being a better build than mine!

Quote:

---

Originally Posted by Zandit75

Yep, pretty much as Wokka described. I still have some ridges in my finish, but then I probably only did about 7-8 final coats of DT that were very thin.
Don't go comparing mine to yours!! Depending on how you execute your design plan, it could easily end up being a better build than mine!

---

Nah no comparisons... each build is unique... but that veneer you got was bloody awesome!

Quote:

---

Originally Posted by Slayer666

Nah no comparisons... each build is unique... but that veneer you got was bloody awesome!

---

Yeah, I got pretty lucky with that one!

Finally got my final DT stain coats started... just the top coated so far but looks great... to me anyways.

Do you rub back a little with final DT coats?

Cheers Paul Attachment 18680Attachment 18681