wow Fred just seen the pics after the polish, looking sweet
Printable View
wow Fred just seen the pics after the polish, looking sweet
Yep definitely looking sweet.
Thanks guys.
Still need a few hours of polishing, then electronics to be soldered.
Just need more time!
Sent from my SM-G935F using Tapatalk
Finally got to do the electronics.
That 6 way switch and the push pull tone pot make things intersting!
Used coloured wires to help future troubleshooting: red is bridge pup, green middle and blue neck.
Then yellow is out to tone and to push pull switch, and orange adds neck and bridge to get all 3 pups at one in position 5...
Did I hear that's crazy? [emoji848]
I used old style wires to connect the jack and tried to tie cables together so it doesn't become a mess in the control cavity.
Now have to put copper tape, install electronics and cable the pups to their vol pots.
Getting there!
https://uploads.tapatalk-cdn.com/201...a510d971c7.jpghttps://uploads.tapatalk-cdn.com/201...c32169b707.jpghttps://uploads.tapatalk-cdn.com/201...7ff86c14cd.jpghttps://uploads.tapatalk-cdn.com/201...2c622e8a93.jpg
Sent from my SM-G935F using Tapatalk
Nice tidy wiring Harness Fred.
Cheers. Glad I'm done with that cabling...
Had a small issue when hammering in the bridge post ferules, the poly cracked and lifted...
I reapplied some poly where it cracked and it looks better, i'll apply a couple more coats and repolish around that area...
Had a lot of drama with the poly finish on this build. I think that will be my last one finished with poly...https://uploads.tapatalk-cdn.com/201...4a7469f5e6.jpghttps://uploads.tapatalk-cdn.com/201...d92b38442d.jpg
Sent from my SM-G935F using Tapatalk
And looking at the photos of the cabling, I just realised I messed up the connection to pot for middle pup, I connected to the middle lug instead of the side one...
Must be tired, I'll fix next time, enough for today...
Complex wiring does take a lot of concentration.
Hey Fred, are you still chasing replacement PUP's for your IB5? There is a set of EMG passives for a fiver on eBay for $100 that I reckon would fit.
http://www.ebay.com.au/itm/EMG-40HZ-...53.m1438.l2649
Hey Waz, not chasing anymore. Adam is ordering a set of Bensons for me [emoji41]
Cheers
Now I've got to order a couple of push pull pots or something like that to switch to single coil... Maybe I should replace the blend and master vol pots by 2x vol pots with push pull... or change the tone pots to push pull...
How did you cable yours?
Sent from my SM-G935F using Tapatalk
Hi Fred, on the EX-5 it originally had 2 x Vol & 1 x Tone and when installing the Bensons I used a couple of Bourns 500k audio taper push pulls to split the coils and also operate as master volume & master tone with a Gotoh LP style 3 way switch installed for PUP selection.
When they arrive let me know and I will take a photo of the control cavity to help you with which wires do what for coil splitting.