Printable View
They're both audio taper. I know there's lots of discussion on which is best, log or linear, but I don't mind both vol and tone being log.
I was planning on setting the larger lower ring knob as volume and the top knob as tone.
With the forward pot for neck, rear for bridge and the 3-way switch up for neck and down for bridge.
As close to a standard layout using 2 controls for 4.
Sounds like you're all sorted and ready to go then.
Still going on this. Postponed the electronics build when a test stringing buzzed a bit more than I think it should.
Tapping them with a fret hammer didn't change them much if at all. The neck measures as straight - least as far as I can tell from the edges. Anyone know where I can get a slotted straight edge? Have a vague memory someone on here was making perspex ones?
Radius gauges arrived and I think the fretboard is a 12. So now I also need to get a size 10 radius sanding block to dress the frets.
Probably going to renew work on the electronics soon.
(With luck will finish before two years from start.)
(edit: Thought it might have been 10", but now I think it's 12")
WOW this build has been going on longer than I've been a member of this forum. I really hope to see it finished!
Indeed, me too :)Quote:
Originally Posted by Andy40
Pablopepper makes them and is excellent to deal withQuote:
Originally Posted by Tindrrel
I've got one and I use it ALL the time! (thanks Pabs)Quote:
Originally Posted by billb
Update on this build.
Finally installed the electronics. Reasonably happy.
Tweaking the setup. Need to turn the saddles around.
Welcome back Tindrrel.