Custom Pickups - Have your say!

Guys, an idea struck me this morning... The picture speaks for itself... Also, if you want to, share your own custom pup designs, this design is mine!!!
-[(c) Pest]-

http://pitbullguitars.com/wp-content...tom-Pickup.png

A semi-bucker??

Quote:

---

Quote from Bass Guy on March 26, 2013, 16:57
A semi-bucker??

---

Not really, mainly a new design, I doubt it would dramatically change the tone, yet there's a chance it might... These customs will also have custom covers!

Here's some I prepared earlier. =)

Fender used these In some Tele's.
http://pitbullguitars.com/wp-content...710k-image.jpg

Pest you need to somehow get PCG over as much hardware as you can - Pest Custom Guitars !
I'm not a fan of non symmetrical humbuckers, you either have 6 screws or none in my opinion

Haha Yer, I want to wind some Pest's Pups hahaha!!!

Quote:

---

/<\\/p>[]<\\/p>/Quote from keloooe on July 30, 2013, 18:58
Haha Yer, I want to wind some Pest's Pups hahaha!!!

---

Has a nice ring to it. Put me on the waiting list. I'll have a set with pole pieces like this. ;)
Call it a triple stagger. It's probably been done before aswell.
http://pitbullguitars.com/wp-content...7tdj-image.jpg

man i am liking the new ,, Lace Alumitone Humbucker Pickups
- Replacement for standard size humbucker
- Available in - silver, gold, blue, pink, green & red colours plus bling & country motifs

The first pickup from this century. Huge top and bottom end. Huge passive design. The coolest looking pickup available.

This radical departure from pickup design is aluminum based, rather than copper. Result: less resistance, higher output coupled to a "current driven design" as opposed to conventional voltage based pickups.

The aluminum water jet cut exoskeleton is then matted to a micro winding using 90% less fine copper wire, a low impedance/high impedance pickup is then created.

very kool -- but runs about $350 a pair also available in single coil double rail and there split coil !!!!!
http://pitbullguitars.com/wp-content...QEsMQ60_35.JPG

Yeah they are some sweet looking pups. And the tech behind them is very cool.
From what I've heard from them they sound ok. Great for metal but the cleans sound a little sterile. Just from the few YouTube clips I've seen, most clips were using tons of distortion though. So it's hard to tell.