Precision Bass pot wiring

[Corbs]

Hi. I have the precision bass electrics - 2 pickups and vol and tone pots. The yellow wire broke off the pot, so I am needing check which connection to solder it back on to. Its a yellow wire with a short section of white wire at the tip. Its seems that both the white section and a portion steaming from the yellow need to be re-soldered. Is there an image I can get for reference? Much thanks, Corbs

[Brendan]

Hey Corbs - keen to help - drop us a photo of the back and we can point you in the right direction - have wired one or two PB's in the past so should be able to assist.

[Corbs]

Hi Brendan. Thanks for getting back to me and offering to help. Pls see attached photo. Cheers, Corbs

[Simon Barden]

The white wire goes to the middle tag on the volume pot, whilst the twisted screen gets soldered to the back of the volume pot.

[Corbs]

Further to last message. This photo shows end of the yellow wire. Cheers, Corbs

[Simon Barden]

You'll need to strip some insulation off the white part of the wire so you can solder the signal wire onto the centre tab on the pot.

[Corbs]

Beautiful thanks Simon.