My first build GTL-1

[Sime O]

Okay so string trees attached, now I have one last piece remaining that I’m not sure about.
Where does this go? Or perhaps is it just to help get the string trees on easier?

[DarkMark]

Looks like a piece of solder. I’m not sure where those go either. Electronics is not my strength.

[Simon Barden]

Put the B/E tree on, then compare the string angle of the G and D strings. If they are very close to the the same as the B and E strings, then there's no point. If they are shallower, then fit the tree.

Edit: Oops. Too late.

[Sime O]

So I finally ordered an amp but it took a little while to arrive so I used that time to refinish the body as it was a bit patchy. It came up much better this time. I just tried to torch the grain instead of the whole body. I’m so glad I did. After re assembly the it would play thru the amp but I found I had the hot wire and ground for the jack around the wrong way. A quick re solder and it plays a treat. I’m really happy with it. Even happier to be finished. Thank you for all the input along the way.

[McCreed]

I like the new finish job better! It's more refined (in a rustic sort of way!).

Good job on your first kit! Glad it plays well for you too.

[gpjt]

Looks amazing!

[Andy40]

great work Sime O. looks the business.

BTW which amp did you order/get?

[Sime O]

I got an orange crush 20. I really like it.

[DarkMark]

I think that looks much better.
Next, the sound demo 😉