I had sanded my guitar down to 1200 then after receiving my dingotone and Instructions, I sanded the guitar again with a 400. On applying the stain, there were a few spots where stain was not getting through to the wood. I assumed that I had over sanded these spots with the 1200 grit and when I sanded again at 400, most of these unstained spots were in the curves as if I didnt get them sanded to 400.

I decided to give the spots a sand and reapply, but they only got worse. I am at 4 days and I dont know whether to keep going and accept the flaw or try and find a solutiion.

I certainly would appreciate hearing from anyone who has had a similar problem or anyone who might have a solution? Thank you