Dingotone boo boo

[wheat]

I had sanded my guitar down to 1200 then after receiving my dingotone and Instructions, I sanded the guitar again with a 400. On applying the stain, there were a few spots where stain was not getting through to the wood. I assumed that I had over sanded these spots with the 1200 grit and when I sanded again at 400, most of these unstained spots were in the curves as if I didnt get them sanded to 400.

I decided to give the spots a sand and reapply, but they only got worse. I am at 4 days and I dont know whether to keep going and accept the flaw or try and find a solutiion.

I certainly would appreciate hearing from anyone who has had a similar problem or anyone who might have a solution? Thank you

[Fretworn]

Hi wheat, are you able to post some photos. It would definitely help us work out what is going on.

[wheat]

Uploading picture failed d

[Sonic Mountain]

The forum uploader is a bit finicky with image size and resolution. There are a couple of ways you can get images in your post. I like Imgur, which you can use by following the instructions in this link:


https://www.buildyourownguitar.com.a...ead.php?t=8108

[Jendall714]

Finished my Explorer Style Guitar today, I did a modification, moved the toggle switch to where it should be on the top point and added another tone knob, where the switch had been.

[wheat]

Thank you very much, the finish is looking better after taking the step to continue with the Intensifier. Ill still try and get pics up.