Hi All,
Im looking for a little assistance; im putting together a Rickenbacker Kit and i have done all the wiring, ready to mount the controls onto the scratch plate (as is the case with RBs) ... my issue is this; the pots dont sit flush on the back side of the plate - there is a small "dag" that sets the threaded shaft off center when i apply the nut to the front - this means that the nut never seats properly and the whole thing ends up not sitting straight. Is this normal? should i be looking for another "piece" that i should be installing. Cutting the "Dag" seems out of the question - it is quite thick and doesnt bend - my guess is "leave it alone" ... Any ideas? Pic attached
Cheers all
G8tr