Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
The rails are the right idea, I’d modify your mounting plate to a sled arrangement so that you can move the router along the sled between your rails, and the sled itself down along your rails. That way you are not having to move the whole mass off the router and the mounting plate
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
You just need to cut a slot lengthwise down your mounting board to the router to run along. A couple of straight guide rails that are just wider than Your router base and you’re sweet.
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
Yeah I saw a similar setup online using sliding door runners, but what I really need is to be able to lock one axis.
So I did this, I drilled a bunch of holes and put movable stops in them to let me do more even passes. Worked quite well, but because the other side of the wood isn't flat it rocks around a bit making consistent depth difficult. Anyway, it was enough to remove 5-10 mm from each side and then I hit it with a cheap electric planer. It's getting pretty good. A few more passes and I think it's be right to move onto power sanding.
Sprayed it black so I could see what I was doing a bit better
Still some small cracks here and there that I'm not sure I'll get out, so there will be a bit of filling required here and there. Should be OK I think - a little way off doing that yet anyway.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
What width bit are you using?
I have it in my head to set up something similar on the bench i'm building, but the rails will be steel box section milled true on two sides.
The sled will have wheel mounts to glide along the tops of the runners and hold it in place on the faces. Just got to finish the bench!
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
A really small one..15mm? Totally the wrong tool for the job, but its what I have already. That setup sounds similar to the one with there sliding door fixings. There are some great bits of channel with wheels to suit at the BGS in the castors section.
Some more hack and slash. Had enough noise and dust for the day I think.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
edit double post
Dammit! I knew I was remembering something about a camphorwood guitar!
First (proper) build: http://www.buildyourownguitar.com.au...ead.php?t=8546
Second build: http://www.buildyourownguitar.com.au...ad.php?t=10229