Humbucking Tele/Strat with a rotary switch?

[fender3x]

So I now have a set of Lil' Punchers Tele twin blade pups and an HSS strat body.

I found a Strat pickguard routed for Tele Pickups. This pickguard comes ready for a Strat switch and three knobs.

So....I started wondering what to do with that.

I think I have figured out a way to get...
H+H
H+S
S+H
S+S (non-humbucking)

...with a 2-pole 4-position rotary switch.

Adding a push pull, I think I can make the S+S setting humbucking.

If it works it should be useful for anyone who wants to do a 2 humbucker Strat with a standard 3 hole, switch slot pickguard. if it works...

So here's a sketch...did I get it right?


Sent from my ONEPLUS A3000 using Tapatalk

[fender3x]

BTW, I just realized the cap is wired wrong. It should be one leg to the center tone pot lug. The other leg to ground.

Sent from my ONEPLUS A3000 using Tapatalk

[fender3x]

Oops. Meant to bump this thread...

[fender3x]

Corrected the cap... would be grateful to have someone take a look to see if this will work. I suppose that there is no rush. I started this project in about 1986...

[WeirdBits]

Yep, that should do what you want. To help reduce possible noise when the neck is in south-single mode, you may want to switch the Neck North Finish link to the rotary via the push/pull too so that the north coil is not 'hanging' when the push/pull is up.

[fender3x]

Thank you! That makes perfect sense, and I am sure I would never have thought of it.

Sent from my ONEPLUS A3000 using Tapatalk