Results 1 to 3 of 3

Thread: How to wire JBA-4 Bass pickups?

  1. #1
    Member
    Join Date
    Jan 2019
    Location
    Perth, WA
    Posts
    5

    How to wire JBA-4 Bass pickups?

    Hi All,



    I was wondering if I'm going to be wiring my JBA-4 pickup right? This all came from the kit so I'll have to refer to the wiring diagram on the PitBull website (I don't know which on is the live or ground).

    https://www.pitbullguitars.com/wp-co...B-4_2014v2.pdf

    So according to the website above, I would wire the white sheathed wire (see below) to the bottom of the knob, which leads to the ground at the bridge, and wire the unsheathed wire to the pins?

    https://imgur.com/gallery/3P5ZlOI

    Just trying to discern what the guide is saying and confirming my interpretation, as it's a bit vague (or I'm just stupid). If you need me to post more images feel free to ask, though they'll probably imgur links as I can't seem to upload images straight from my laptop onto the forums...



    Thanks in Advance!

    Redmanion

  2. #2
    Overlord of Music Simon Barden's Avatar
    Join Date
    Oct 2016
    Location
    Reading, UK
    Posts
    4,930
    The bare wire that forms the sheath around the signal wire always goes to the back of the volume pot. The signal wire with the white insulation) is soldered to the central lug of the volume pot.



    Note that on the volume pots, the lug shown folded back to touch the pot casing should also be either directly soldered to the pot casing, or (if the lug isn't long enough to easily reach the pot casing) a bit of wire should be soldered connecting the lug and the pot casing/ground. I've never seen the pre-wired parts on one of these kits so don't know if that is done for you or not.

  3. #3
    GAStronomist wazkelly's Avatar
    Join Date
    Aug 2015
    Location
    Caloundra West, Sunshine Coast Qld
    Posts
    6,268
    From memory JB control plates usually come pre-wired so all you need to do is attach pickups as shown in that diagram and also run an earth wire up under the bridge. Best to strip back about 2 cm to sit under the bridge and remember to 'tin' this bit too.

    Cheers, Waz
    # 1 - EX-5 https://goo.gl/fQJMqh
    # 2 - EX-1 https://goo.gl/KSY9W9
    # 3 - Non PBG Tele https://goo.gl/W14G5g
    # 4 - Non PBG J Bass https://goo.gl/FbBaFy
    # 5 - TL-1AR GOTM Aug 2017 https://goo.gl/sUh14s
    # 6 - MMB-4 Runner-up GOTM Oct 2018https://goo.gl/gvrPkp
    # 7 - ES-1 Runner-up GOTM Aug 2018https://goo.gl/T9BEY8

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •