Right, here we go again. After almost a year's lay off due to health then winter in Australia, I've purchased this kit from Adam. It's a much nicer body than last year's Thinline, with a thicker top and Flame Maple veneer.
So I'm planning what colour to do this one. Blue or deep red but I keep coming back to blue, similar to Woltz's build.
Slight problem out of the box with the size of the neck cavity, almost 1mm too small. Quite a bit of sanding from both sides to get the neck to fit.
I don't wanna use the entire pickguard as I don't want to hide the grain of this guitar. Any suggestions as to how I can get a plate that will cover the curved control cavity, or just sheer off the last few inches to cover the cavity and hold the electronics???