Alright I am coming into the home stretch of the staining finishing process, looking to do a final cut and polish on the Dingotone final coat. I have seen lots of builds using the Meguiar's car polish and micro mesh sanding pads on Tru oil finishes, does this same method hold true for Dingotone? I am not trying to get a glass like finish, just a nice even semi-gloss that shows off the grain. I have done 4 top coats with very light wet and dry sand at 1200 then 1500 between every second coat to get some of the dust particles and stray fibres off and to key it up for the subsequent coat, is this sounding about right?