Finally managed to get parts ordering done this week to progress this build, ink stain ordered, full electronics and binding from Real parts and a set of Artist Bullbuckers. Being the first time routing a binding and using a 2 part epoxy and trying to do a burst i think i might make a mock body and run some trials to see if I don't make too big a dogs breakfast of everything first. Started mucking around with the comic collage too and once i get the picture sizing right i think it will look great. Once I get a rough layout right I think I'll go to Officeworks, get them printed out on decent paper then do final cut and positions then re-copy so it is just one layer of paper, hopefully that means the epoxy doesn't have to be that thick to top.