As I am working on the finish and thinking ahead, I have been watching the videos online, however, the glue on neck video says not available. FYI.
So, What type of glue is appropriate for the neck?
As I am working on the finish and thinking ahead, I have been watching the videos online, however, the glue on neck video says not available. FYI.
So, What type of glue is appropriate for the neck?
Titebond Original
Build #1 - ST-1 - Completed
Build #2 - LP-1SS - Completed
Build #3 - TLA-1R - Completed
Build #4 - SGD-612 - Completed
Build #5 - ES-1G - Completed
Build #6 - STA-1HT | Completed
Build #7 - ST1JR - Completed
Current Build #8 - JBA-4
Build #9 - Semi-scratch build Tele x 2 - Completed
Current Build #10 - PRS-1H
Current Build #11 - AGJR-1 - Completed
Current Build #12 - ATL-1SB
Current Build #13 - GST-1
Current Build #14 - FBM-1
As I continue the finish and think about the future steps, I have seen the guitar videos that show measuring to the frets and to the bridge. Are there measurements I should check for this bass as well?Originally Posted by wortzchris
Measurements are done the same way for bass- take off point of nut to the crown of the 12th fret should equal 12th fret to bridge
And yes titebond original is the way to go for neck joints, good luck
Stan's LP Build for my Sister: http://www.buildyourownguitar.com.au...ead.php?t=3146
Benson Pickup Strat mod: http://www.buildyourownguitar.com.au...ead.php?t=5229
Epiphone LP headstock fix: http://www.buildyourownguitar.com.au...ead.php?t=3410
Martin Backpacker Repair: http://www.buildyourownguitar.com.au...?t=5038&page=3
'57 Harmony Jazz guitar project: http://www.buildyourownguitar.com.au...ead.php?t=2972
Has anyone performed this build with different pickups? If so, what pickups?
Reply With Quote
