I've just got to the assembly stage of an Ex1, and found that the bridge spacing centre to centre is 74mm, but the body is drilled for 72mm, centre to centre.
I've looked online and bridges all seem to be standard 74mm size.
I'm not inclined to want to ruin my sonic blue nitro finish by filling the holes and redrilling for new post holes. It would be easier to start over with a new body.
A thought was to ? drill out the post holes in the bridge itself, 1mm on each post closer to centre, leaving oblong slots instead of round holes.
I can work around most things, but this has me stuffed.
Any advice would be greatly appreciated.
Cheers,
Colin