Yes, I just threw them on there. There's also a 3 way switch to go in there too. Ideally it would be smaller, but the hole underneath is big... haven't drilled the holes yet.
Yes, I just threw them on there. There's also a 3 way switch to go in there too. Ideally it would be smaller, but the hole underneath is big... haven't drilled the holes yet.
great save!
Build 19 PSH-1 Kustom
Build 18 HB-4S Kustom
Build 17 WL-1 Kustom
Build 16 TL-1TB Kustom
Build 15 PBG-2-
Build 14 FTD-1
Build 13 RD-1 Kustom
Build 12 DM-1S
Build 11 MKA-2 -
Build 10 Basic strat
Build 9 JM Kustom
Build 8 FV-1G
Build 7 ES-2V
Build 6- Community prototype
Build 5 LP-1LQ
Build 4 ES-5V
Build 3 JR-1
Build 2 GD-1
Build 1 TLA-1
SHIIIIIINYYYY! You have to be happy with where you've taken this one Andy. That's a great save all up and that gloss, well,
I know I'm repeating myself here, but .....SHIIIIIINYYY!!!
FrankenLab
Hand crafting guitars, because Death Rays are expensive.
nice one Andy whatever you did it looks great !
that plastic nut looks very high so will need the slots lowered or bottom of nut sanded
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
looking good Andy, yes a bone or brass nut will make it play much nicer for sure. Also the bridge saddle heights are probably different to the kit supplied bridge so you will have some setup tweaking to do
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Yes I think the bridge saddle heights are too high. I'm planning on having to grind a little off of the bottom of them to allow them to sit lower in their slots, but I'll get some strings on it and get it up to tension and let it sit for a few days first.
Last edited by Andyxlh; 29-11-2016 at 05:15 PM.