Hi guys
I'm thinking about doing a FB-1 build soon, but I kinda want the neck to be set/glued in. Wondering if anyone else has seen any techniques that could be used for something like this.

I was thinking about doing a layer of wood glue between the neck, and using the screws to hold it together till the glue sets. Once the glue has set I'd remove the screws, using a drill I would widen the guide holes by a few mm. And to fill the holes and add support I would use dowels, and wood glue to basically act as the screws. After all that do a bit of sanding over the areas where the dowels were inserted, and filling in of the gaps between the neck and body with a wood glue and saw dust mixture.

Any ideas? Or should I leave it a bolt on neck?