Hi all some time ago I purchased the GR1SF Kit. The laminated body was faulty on receipt and PBG promptly sent me a second kit when I returned the first one.
I followed all the instructions to the letter and all went well... some months later I got back into it to do the wiring. On inspecting the finished construction I noticed the neck was not level E to E along the whole length. I thought this was weird as I had been very careful gluing and clamping the neck in its socket.
I inserted a pair of level check rods - 1 at the bridge and 1 at the nut and it showed the neck was out of square by about 3 or 4 mm. The neck and body had the same numbers stamped so they were not unmatched.
My question is: Does anyone know how to safely remove the glued-in neck without damaging any parts. I used Titebond III Ultimate. Is it a lost cause?
Any advice appreciated.
Mike