It's a good use for the switch, but I tend to thrash about when playing live so the less controls for me to mess with the better - I was considering going to a volume only, but I'm guessing that the single coil might need a live tone tweak.
I'm leaning towards cutting the control plate with a grinder along that line, saving the chrome plating and just gently finishing the edge, then making a small timber insert for the hole to shorten it, allowing the cables to pass under this insert. that's today's idea anyway.
For finish, I'm tempted to stain the body black japan, sand most of it off leaving it in what little grain the basswood has, thin coat of enamel matte white followed by the red I had left over from the Frankenbass.
Then an argument with my plumber's torch, 80 grit paper, thinned-down oak Feast-Watson timber stain to knock back the red to a maroon and give the timber an aged yellow glow and finally a few generous coats of satin poly clear to seal it in and give the basswood a bit more hardness. Thoughts
?