This is my first build. I'm making lots of mistakes, but I'm patient & learning alot as I go.
I'm building the SSCM-1F kit.
I've started putting down my colour scheme (haven't applied clear coat yet) on the weekend I was positioning the pickup rings.
I noticed the neck connects directly into the pickup cavity & doesn't leave enough room for the pickup rings to sit square.
If I slide the neck further out/up of the cavity (to make more room for the pickup rings), it leaves a huge gap under the neck & doesn't fit correctly (see last picture).
Has anyone else experienced this issue & do you have any suggestions on how to address it? I just wanted the pickup rings to sit neatly around the cavity, but the position of the neck doesn't leave enough space to allow this to happen?